Configuration Tab - 2.2 English

PG238 MIPI DSI Transmitter Subsystem Product Guide

Document ID
PG238
Release Date
2022-04-26
Version
2.2 English

The Configuration tab page provides core related configuration parameters. The subsystem configuration screen is shown in This Figure .

Figure 4-2: Customization Screen - Configuration

X-Ref Target - Figure 4-2

PG238_MIPI_DSI_Configuration.png

DSI Lanes : Specifies the number of D-PHY lanes for this subsystem.

Input Pixels per beat : Specifies the number of pixels per clock received on AXI-4 Stream Video interface.

DSI Data type : Specifies the Data Type (Pixel Format) as per DSI protocol (RGB888, RGB565, RGB666_L, RGB666_P, Compressed).

DCS Command Mode : Includes DCS command mode logic in controller sub core.

CRC Generation logic : Includes CRC generation logic for long packets.

Enable Initial Deskew Transmission : When set, the core generates initial skew calibration packets.

Note: Periodic Deskew is not supported.

Line Rate (Mb/s) : Selects the line rate for the MIPI D-PHY core. Vivado®IDE automatically limits the line rates based on the selected device. For details about family or device specific line rate support, refer to the data sheet for your device.

For 7-Series devices, the internal IP timing is tested and validated up to maximum value of 1152Mb/s (For example, On ZC702). Depending on setup, meeting timing at higher line rates is possible. GUI provides option to configure higher line rate.

Note: Internal timing limitations are different than physical timing limitations which are based on the PCB configuration and may be lower. The variables include external PHY, resistor network, and termination options. Ensure to validate the line requirement pf design with full system handling.

LPX Period (ns) : Transmitted length of any low-power state period.

Enable AXI-4 Lite Register I/F : Select to enable the register interface for the MIPI D-PHY core.

Guarantees the clock Rising Edge Alignment to first payload bit on serial lines : This option is available for Versal® TX configuration when selected the first payload bit will be aligned to rising edge of the serial clock.

Infer OBUFTDS for 7 series HS outputs : Select this option to infer OBUFTDS for HS outputs.

Note: This option is available only for 7 series D-PHY TX configuration. It is recommended to use this option for D-PHY compatible solution based on resistive circuit. For details, see D-PHY Solutions (XAPP894) [Ref 17] .