Resets - 2.2 English

PG238 MIPI DSI Transmitter Subsystem Product Guide

Document ID
PG238
Release Date
2022-04-26
Version
2.2 English

DSI Transmitter Controller has one hard reset ( s_axis_aresetn ) and one register based reset (soft reset).

s_axis_aresetn : All the core logic blocks reset to power-on conditions including registers.

The soft reset resets the Interrupt Status register (ISR) of DSI TX Controller and does not affect the core processing.

The subsystem has one external reset port:

s_axis_aresetn : Active-Low reset for the subsystem blocks

The duration of s_axis_aresetn should be a minimum of 40 dphy_clk_200M cycles to propagate the reset throughout the system.

The reset sequence is shown in This Figure .

Figure 3-5: Reset Sequence

X-Ref Target - Figure 3-5

link1_aJP9JDL1_t.jpg

Table: Subsystem Components summarizes all resets available to the MIPI DSI TX Subsystem and the components affected by them.

Table 3-6: Subsystem Components

Sub-core

s_axis_aresetn

MIPI DSI TX Controller

Connected to s_axi_aresetn core port

MIPI DPHY

Inverted signal connected to core_rst port

AXI Crossbar

Connected to aresetn port

Note: The effect of each reset ( s_axis_aresetn ) is determined by the ports of the sub-cores to which they are connected. See the individual sub-core product guides for the effect of each reset signal.