The Program Section of the ECO Navigator, shown in the figure below, provides access to the commands that allow you to save your modifications, generate a new BIT file for programming and a new LTX file for your debug probes, and program the device.
Figure 1. ECO Navigator Program Commands
- Save Checkpoint As
- This command allows you to save your modifications to a new
checkpoint.
- Generate Bitstream
- This command allows you to generate a new .bit file for programming.
- Write Debug Probes
- This command allows you to generate a new .ltx file for your debug probes.
If you made changes to your debug probes using the Replace Debug Probes
command, you need to save the updated information to a new debug probes file
(LTX) to reflect the changes in the Vivado Hardware
Manager.