The open_run command opens a previously completed synthesis or implementation run, then loads the in-memory design of the Vivado tools.
open_runcommand works in Project Mode only. Design runs are not supported in Non-Project Mode.
open_run before implementation on
an RTL design to open a previously completed Vivado synthesis run then load the synthesized netlist into memory.
Tip: Because the in-memory design is updated automatically, you do not need to use
synth_design. You need to use
open_runonly to open a previously completed synthesis run from an earlier design session.
open_run command is for use with
RTL designs only. To open a netlist-based design, use
open_run [-name <arg>] [-quiet] [-verbose] <run>
open_run Example Script
# Open named design from completed synthesis run open_run -name synth_1 synth_1
open_run example script opens a design
synth_1) into the Vivado tools memory from the
completed synthesis run (also named
If you use
open_run while a design is already in memory, the
Vivado tools prompt you to save any changes to the current
design before opening the new design.