Step 1: Generating a Zynq UltraScale+ MPSoC PS Xilinx Support Archive - 2021.2 English

Vivado Design Suite Tutorial: Programming and Debugging

Document ID
UG936
Release Date
2021-11-10
Version
2021.2 English
  1. Open the Vivado IDE.
  2. Click Create Project, and click Next.

  3. Set your project name, and specify the project directory. Click Next.
  4. Select Project type as RTL project.
  5. Select do not specify sources at this time checked, then click Next.
  6. To choose the board, click the board icon, and select Zynq UltraScale+ ZCU102 Evaluation board, with Board Rev 1.0. Click Next.

  7. The project summary displays. To create the project, click Finish.
  8. In the Flow Navigator, select Create Block Design. You can specify the design name and directory, but it is not necessary for a local project directory. Click OK to create the block design.

  9. An empty design diagram displays. Click the Add IP button to add IP. Select the IP based on the selected board (for the ZCU102 evaluation board, search for Zynq UltraScale+ MPSoC) and double-click the selected IP.

  10. In the design diagram window, select Run Block Automation. Click OK to continue creating the ZCU102 design.

  11. When the design diagram appears, use the following steps to validate the design:
    1. Connect maxihpm0_fpd_aclk and maxihpm1_fpd_aclk together to pl_clk0, as shown in the following figure.
      1. Select maxihpm0_fpd_aclk and drag it to maxihpm1_fpd_aclk.
      2. Select maxihpm1_fpd_aclk and drag it to pl_clk0.
    2. Right-click the Zynq UltraScale+ MPSoC block and select Validate Design to validate the design. It will say validation successful. Click OK.

  12. Customize the design by double-clicking the Zynq UltraScale+ MPSoC block and configuring the parameters. There are four valid GT configurations for ZCU102 board as shown in the following table.
    Table 1. Supported PS-GTR Connector Functionality
    SEL (S3,2,1,0) ICM Settings (Lane 0,1,2,3) PCIe Connector DP Connector USB Connector SATA Connector
    0 0 0 0 PCIe.0, PCIe.1, PCIe.2, PCIe.3 PCIe Gen2 x4 N.C. N.C. N.C.
    1 1 1 1 DP.1, DP.0, USB, SATA N.C. DP.0, DP.1 USB0 SATA1
    1 1 0 0 PCIe.0, PCIe.1, USB, SATA PCIe Gen2 x2 N.C. USB0 SATA1
    1 1 1 0 PCIe.0, DP.0, USB, SATA PCIe Gen2 x1 DP.0 USB0 SATA1
  13. Select the settings based on your requirements by double-clicking the Zynq UltraScale+ MPSoC block to customize GT Lane configuration.
  14. Select I/O Configuration > High Speed. Select one of the four combinations using the settings in the following screenshots.
    1. PCIe – Display Port - USB - SATA (Default Vivado preset)

    2. PCIePCIe - USB - SATA

    3. Display Port – Display Port - USB - SATA

    4. PCIePCIe - PCIe - PCIe (PCIe x4)