Check Inferred Logic - 2021.2 English

UltraFast Design Methodology Guide for Xilinx FPGAs and SoCs

Document ID
UG949
Release Date
2021-11-19
Version
2021.2 English

As you code your design, be aware of the logic being inferred. Monitor the following conditions for additional pipelining considerations:

  • Cones of logic with large fanin

    For example, code that requires large buses or several combinational signals to compute an output.

  • Blocks with restricted placement or slow clock-to-out or large setup requirements

    For example, block RAMs without output registers or arithmetic code that is not appropriately pipelined.

  • Forced placement that causes long routes

    For example, a pinout that forces a route across the chip might require pipelining to allow for high-speed operation.

  • Logic comprised of large XOR functions

    Large XOR functions often have high switch rates that can generate large dynamic power dissipation. Pipelining these functions can reduce switching, which positively impacts power consumption of the described circuit.

In the following figure the clock speed is limited by:

  • Clock-to out-time of the source flip-flop
  • Logic delay through four levels of logic
  • Routing associated with the four function generators
  • Setup time of the destination register
Figure 1. Before Pipelining Diagram

The following figure is an example of the same data path shown in the Before Pipelining diagram. Because the flip-flop is contained in the same slice as the function generator, the clock speed is limited by the clock-to-out time of the source flip-flop, the logic delay through one level of logic, one routing delay, and the setup time of the destination register. In this example, the system clock runs faster after pipelining than before pipelining.

Figure 2. After Pipelining Diagram