Schematic Window Display Settings - 2022.1 English

Vivado Design Suite User Guide: Using the Vivado IDE (UG893)

Document ID
UG893
Release Date
2022-04-27
Version
2022.1 English

The Display settings (shown in the following figure) control the display of the following features in the Schematic window:

Inst Equation
Labels cells with truth table equations.
Fanout for Scalar/Bus Pin
Labels cell pins with fanout values.
Setup Slack for Scalar/Bus Pin
Labels destination pins with slack values. Slack values do not display until after data is generated by Report Timing Summary or Report Timing. For more information, see this link in the Vivado Design Suite User Guide: Design Analysis and Closure Techniques (UG906).
Note: If you updated timing data, you must refresh the schematic to display the new slack values.
Static Probability for Scalar/Bus Pin
Labels nets connected to cell pins with static probability. For more information, see this link in the Vivado Design Suite User Guide: Power Analysis and Optimization (UG907).
Toggle Rate for Scalar/Bus Pin
Labels the net connected to cell pins with toggle rate. For more information, see this link in the Vivado Design Suite User Guide: Power Analysis and Optimization (UG907).
Note: Static probability and toggle rate values do not display until after data is generated by the Reports > Report Power command. If you update the power data, you must run the Report Power command again to display the new static probability and toggle rate.
Bus Value
Labels bus pins with bus values.
Elide Long Text
Truncates long text for a cleaner display.
Bundle Nets/Cells
Shows buses or cells as a bundled net.
Split into Multiple Pages
Shows large schematics on multiple pages.
Figure 1. Schematic Window—Display Settings