- After selecting Next to
progress past the introduction, the first content page allows you to define new
RMs for any Partition Definitions (PD) defined. The first RM for each PD has
already been included here, if the RTL/netlist source was present when the PD
was created. Click on the blue + to create
a new RM and give it a unique name. Be sure to select the correct PD if more
than one exists in the design. If netlist sources are selected, select the
Sources are already synthesized check
box and declare the Top Module within the netlist.Figure 1. Creating a New Reconfigurable Module
- Repeat this process for all existing RMs for every Partition
Definition. If a gray box module is desired, no action is required. Note that
RMs may be edited by clicking on the pencil icon or removed by clicking the red
- icon. When all RM are accounted for
click Next.Figure 2. Set of Reconfigurable Modules Defined
