compile_simlibwas invoked or the one you specified with the
-directoryoption) before running a third-party simulation.
From the Vivado IDE, you can compile, elaborate, and simulate the design based on the simulation settings and launch the simulator in a separate window.
When you run simulation prior to synthesizing the design, the simulator runs a behavioral simulation. Following each successful design step (synthesis and implementation), the option to run a functional or timing simulation becomes available. You can initiate a simulation run from the Flow Navigator or by typing in a Tcl command.
From the Flow Navigator, click Run Simulation, and select the type of simulation you want to run, as shown in the following figure:
To use the corresponding Tcl command, type:
-scripts_onlyoption that can be used to write a DO or SH file, depending on the target simulator. Use the DO or SH file to run simulations outside the IDE.
-full64switch. Otherwise, the simulator will not run if the design contains Xilinx IP.
set_property 32bit 1 [current_fileset -simset]