Building the Example Design - 3.0 English

DisplayPort 1.4 RX Subsystem Product Guide (PG300)
Document ID
PG300
Release Date
2022-05-04
Version
3.0 English
  1. Open the Vivado® Design Suite and click Create Project.

  2. In the New Project window, enter a Project name, Project location, and click Next up to the Board/Part selection window.

  3. In the Default Part window, select the Board as per your requirement. Application Example Designs are available for KCU105, ZCU102, VCU118, and VCK190.

  4. Click Finish.

  5. In the Flow Navigator window, click Create Block Design (BD). Select a name for the Block Design and click OK.

  6. Right-click BD and click Add IP. Search for DisplayPort 1.4 and select either the DisplayPort 1.4 Receiver Subsystem IP (for RX only (ZCU102, VCU118), Pass-through (KCU105, ZCU102, and VCK190) designs) or the DisplayPort 1.4 Transmitter Subsystem IP (for TX only (ZCU102, VCU118, and VCK190), or Pass-through (KCU105) designs).
  7. Double-click the IP and go to the Application Example Design tab in the Customize IP window. Select the supported topology in the Application Example Design drop-down box. Click OK and Save the block design.

  8. Right-click the DisplayPort Subsystem IP under Design source in the Design tab and click Open IP Example Design.

  9. Choose Example project directory and click OK.

  10. The following figure shows the Vivado IP integrator design. Choose the Generate Bitstream.

  11. Export the hardware (xsa) to Vitis™ software platform. Click File > Export > Export Hardware.
  12. Launch the Vitis software platform from command line. Setup a workspace and create a platform project using exported xsa.
  13. The following figure shows an example of the launched Vitis platform when built successfully.

  14. Click Board Support Package from Vitis. Locate the row for dp14rxss. Click Import Examples.
    Note: For designs other than RX-Only, the application example is paired with dp14txss.
  15. Select the Example Application corresponding to your hardware:
    • For the RX-only VCU118 project, select the *_dp14_rx_vcu option.
    • For the RX-Only ZCU102 project, select the *_dp14_rx option.
  16. Build the example in Vitis software platform. Right-click and select Build Project.