Software Driver Core Initialization - 3.3 English

1. Initialize other elements of the design such that the clocks including ts_clk and tx/rx_phy_clk* are present and stable. Release resets for these clock domains such as ts_rst, tx/rx_phy_rst*.
2. Configure TOD_CONFIG register:
   1. In Timer or Timer Syncer mode set bit [0] to enable system timer.
   2. If an external ToD bus (1PPS synchronization and optionally serial seconds input) is to be used, then set bit [1] to 1.
   3. Set the mode bit field [3:2] to the setting matching the intended synchronization method used in your system. For example, if your system uses an external device connected to the External ToD bus (1PPS input and second’s value serial input). The mode field should be set to 0x1.
   4. Enable (set to 1) appropriate bits of the Port Timer enable bitfield [19:4] to enable the port TX and RX timers.
3. If the system timer’s initial value is to be set by the software via register programming, an alternative to the external ToD bus interface, then write appropriate initial values to the software loading registers such as TOD_SW_SEC_0/1 and TOD_SW_NS, TOD_SW_CTIME_0/1. Also configure any static offset to be loaded by writing the TOD_SEC_SYS_OFFSET_0/1 and TOD_NS_SYS_OFFSET_0 registers.
4. If the software registers are updated in Step 2, then a write of 1 to the appropriate bits of TOD_SW_LOAD[1:0] triggers system timer to load software values.
5. Program port TX/RX Timer. This includes the period values and any required static offset to the appropriate values by writing to the Port timer’s registers: TX<M>_PERIOD_0/1, RX<M>_PERIOD_0/1, and TX<M>/RX<M>_SYS_OFFSET.

Continue step 4 for all Ports (M) present in the design.