Board Preset - 3.4 English

Zynq UltraScale+ MPSoC Processing System Product Guide (PG201)

Document ID
PG201
Release Date
2022-05-11
Version
3.4 English

For the Zynq MPSoC board, presets are tightly coupled with boards. To obtain the board preset support, you must select the Xilinx board part (for example, ZCU102, ZCU106) when creating the project. The board preset is different from IP presets.

After the Zynq MPSoC IP is instantiated in the board design, the Run Block Automation ribbon appears on the block diagram as shown in This Figure

Figure 4-2: Run Block Automation

X-Ref Target - Figure 4-2

run_block_automation.png

After clicking Run Block Automation , apply Board Preset appears as shown in This Figure .

Figure 4-3: Apply Board Reset

X-Ref Target - Figure 4-3

apply_board_preset.png

You can re-customize your needs after preset is applied, but for the devices earlier than production (es-1, es-2) the Run Block Automation ribbon appears again on the block diagram upon re customization, but you can safely ignore this.