DSP Macro 1.0 - 2022.1 English

Vitis Model Composer User Guide (UG1483)

Document ID
UG1483
Release Date
2022-05-26
Version
2022.1 English

The Xilinx DSP macro block provides a device independent abstraction of the DSP48E1, DSP48E2, and DSP58 blocks. Using this block instead of using a technology-specific DSP slice helps makes the design more portable between Xilinx technologies.

The DSP Macro provides a simplified interface to the XtremeDSP slice by the abstraction of all opmode, subtract, alumode, and inmode controls to a single SEL port. Further, all CE and RST controls are grouped to a single CE and SCLR port respectively. This abstraction enhances portability of HDL between device families.

You can specify 1 to 64 instructions which are translated into the various control signals for the XtremeDSP slice of the target device. The instructions are stored in a ROM from which the appropriate instruction is selected using the SEL port.

Block Parameters

Instruction tab

The Instruction tab is used to define the operations that the LogiCOREā„¢ is to implement. Each instruction can be entered on a new line, or in a comma delimited list, and are enumerated from the top down. You can specify a maximum of 64 instructions.

Refer to the topic Instructions page of the DSP Macro LogiCORE IP Product Guide (PG323) for details on all the parameters on this tab.

Pipeline Options tab

The Pipeline Options tab is used to define the pipeline depth of the various input paths.

Pipeline Options

Specifies the pipeline method to be used; Automatic, By Tier, or Expert.

Custom Pipeline options

Used to specify the pipeline depth of the various input paths.

Tier 1 to 6
When By Tier is selected for Pipeline Options these parameters are used to enable/disable the registers across all the input paths for a given pipeline stage. The following restrictions are enforced:
  • When P has been specified in an expression tier, 6 will be forced as asynchronous feedback is not supported.
Individual registers

When you select Expert for the Pipeline Options, these parameters are used to enable/disable individual register stages. The following restrictions are enforced:

  • The P register is forced when P is specified in an expression. Asynchronous feedback is not supported.

Refer to the topic Detailed Pipeline Implementation of the DSP Macro LogiCORE IP Product Guide (PG323) for details on all the parameters on this tab.

Implementation tab

The Implementation tab is used to define implementation options.

Output Port Properties
Precision
Specifies the precision of the P output port.
Full
The bit width of the output port P is set to the full XtremeDSP Slide width of 48 bits.
User_Defined
The output width of P can be set to any value up to 48 bits. When set to less than 48 bits, the output is truncated (LSBs removed).
Width
Specifies the User Defined output width of the P output port
Binary Point
Specifies the placement of the binary point of the P output port.
Additional ports
Use ACOUT
Use the optional cascade A output port.
Use CARRYOUT
Use the optional carryout output port.
Use BCOUT
Use the optional cascade B output port.
Use CARRYCASCOUT
Use the optional cascade carryout output port.
Use PCOUT
Use the optional cascade P output port.
Control ports

Refer to the topic Implementation Page of the DSP Macro LogiCORE IP Product Guide (PG323) for details on all the parameters on this tab.

LogiCORE Documentation

DSP Macro LogiCORE IP Product Guide (PG323)