VCK190 Hardware Setup - 5.1 English

MIPI CSI-2 Receiver Subsystem Product Guide (PG232)

Document ID
PG232
Release Date
2022-04-26
Version
5.1 English

1. Set up the hardware connections as shown in This Figure .

Figure 5-9: : LI-IMX274MIPI-FMC Camera Sensor Module

X-Ref Target - Figure 5-9

IMX274.png

a. Mount the LI-IMX274MIPI-FMC Camera sensor module on the VCK190 board FMCP1 Slot.

b. Connect the HDMI cable to the VCK190 HDMI port ( This Figure ).

Figure 5-10: HDMI Connections

X-Ref Target - Figure 5-10

HDMI.png

c. Connect the other end of the HDMI cable to the HDMI monitor.

d. Switch on the HDMI monitor, and select HDMI as input source.

e. Connect the USB-JTAG programming cable from host PC to JTAG micro USB port of board.

f. Ensure that the SD card, board switches and jumpers are in position as shown in This Figure .

Figure 5-11: VCK190 Board

X-Ref Target - Figure 5-11

board.png

g. Connect the USB UART and JTAG programming cables to the Windows host computer where xsdb and hw_server is running.

2. Connect the power supply cable and turn on the VCK190 board.

3. Start a Hyper Terminal program on the host PC with the following settings:

° Baud rate: 115200

° Data Bits: 8

° Parity: None

° Stop Bits: 1

° Flow Control: None

Note: Ensure that V adj is set to 1.5V. Refer to the VCK190 board documentation for details.