Capabilities Tab - 1.0 English

Versal ACAP DMA and Bridge Subsystem for PCI Express Product Guide (PG344)

Document ID
PG344
Release Date
2022-05-20
Version
1.0 English

The Capabilities Tab is shown in the following figure.

Figure 1. Capabilities Tab
Total Physical Functions
A maximum of four Physical Functions can be enabled.
PF - ID Initial Values
Vendor ID
Identifies the manufacturer of the device or application. Valid identifiers are assigned by the PCI Special Interest Group to guarantee that each identifier is unique. The default value, 10EEh, is the Vendor ID for Xilinx. Enter a vendor identification number here. FFFFh is reserved.
Device ID
A unique identifier for the application; the default value, which depends on the configuration selected, is 70h. This field can be any value; change this value for the application.

The Device ID parameter is evaluated based on:

  • The device family: B for Versal.
  • EP or RP mode
  • Link width
  • Link speed

If any of the above values are changed, the Device ID value will be re-evaluated, replacing the previous set value.

Revision ID
Indicates the revision of the device or application; an extension of the Device ID. The default value is 00h; enter values appropriate for the application.
Subsystem Vendor ID
Further qualifies the manufacturer of the device or application. Enter a Subsystem Vendor ID here; the default value is 10EEh. Typically, this value is the same as Vendor ID. Setting the value to 0000h can cause compliance testing issues.
Subsystem ID
Further qualifies the manufacturer of the device or application. This value is typically the same as the Device ID; the default value depends on the lane width and link speed selected. Setting the value to 0000h can cause compliance testing issues.
Class Code
The Class Code identifies the general function of a device.
Use Classcode Lookup Assistant
If selected, the Class Code Look-up Assistant provides the Base Class, Sub-Class and Interface values for a selected general function of a device. This Look-up Assistant tool only displays the three values for a selected function. You must enter the values in Class Code for these values to be translated into device settings.
Base Class
Broadly identifies the type of function performed by the device.
Subclass
More specifically identifies the device function.
Interface
Defines a specific register-level programming interface, if any, allowing device-independent software to interface with the device.