CAUTION! ESD can damage electronic components when they are improperly handled, and can result in total or intermittent failures. Always follow ESD-prevention procedures when removing and replacing components.
To prevent ESD damage:
• Use an ESD wrist or ankle strap and ensure that it makes skin contact. Connect the equipment end of the strap to an unpainted metal surface on the chassis.
• Avoid touching the adapter against your clothing. The wrist strap protects components from ESD on the body only.
• Handle the adapter by its bracket or edges only. Avoid touching the printed circuit board or the connectors.
• Put the adapter down only on an antistatic surface such as the bag supplied in your kit.
• If you are returning the adapter to AMD Product Support, place it back in its antistatic bag immediately.
Callout |
Ref. Des. |
Feature [B] = Bottom |
Notes |
Schematic Page |
---|---|---|---|---|
1 |
U1 |
Zynq UltraScale+ XCZU28DR RFSoC fansink |
XCZU28DR-2FFVG1517
|
|
2 |
J50 |
PS-Side: DDR4 SODIMM Socket , w/64-bit DDR4 SODIMM |
LOTES ADDR0067-P001A
|
43 |
3 |
U80, U94-U96 |
Micron MT40A512M16JY-075E |
72-75 |
|
4 |
U17, U18 |
Micron MT25QU02CBB8E-0SIT |
25 |
|
5 |
U12, J96 |
SMSC USB3320-EZK,
|
24 |
|
6 |
J100 |
MOLEX 5025700893 |
28 |
|
7 |
U34, J83 |
FTDI FT4232Hx-REEL,
|
29 |
|
8 |
U46 |
Silicon Labs SI5341B-D07833-GM |
40 |
|
9 |
U47 |
Silicon Labs SI570BAB001614DG |
45 |
|
10 |
U49 |
Programmable User MGT SI570 Clock
, user MGT clock,
|
Silicon Labs SI570BAB000544DG |
45 |
11 |
U48 |
Silicon Labs SI5382B-C-GMR |
39 |
|
12 |
U37, P12 |
10/100/1000 MHz Tri-Speed Ethernet PHY , RJ45 with mag |
TI DP83867IRPAP,
|
30 |
13 |
U22, U23 |
I2C0 (MIO 14-15) , expander |
TI TCA6416APWR,
|
26 |
14 |
U26, U27 |
I2C1 (MIO 16-17) [B] |
Two each TI TCA9548APWR |
27 |
15 |
J27, J32, J37, J42 |
Molex 170382-0001 |
38 |
|
16 |
U42 |
TI MSP430F5342 |
32 |
|
17 |
J48, J49 |
User PMOD GPIO Connectors , PMOD0/1 RA receptacles |
SULLINS PPPC062LJBN-RC |
42 |
18 |
DS11-DS18 |
User I/O , eight user LEDs, active High |
GPIO LEDs, GREEN 0603 |
41 |
19 |
SW9-SW13 |
User I/O
, user pushbutton switches,
|
E-Switch TL3301EP100QG (N,S,W,E,C pattern) |
41 |
20 |
SW14 |
User I/O , user 8-pole DIP switch, active High |
C&K SDA08H1SBD |
41 |
21 |
SW20 |
User I/O , CPU_RESET pushbutton, active High |
E-switch TL3301EP100QG |
41 |
22 |
SW8 |
System controller |
5-pole C&K SDA05H1SBD |
32 |
23 |
SW3, SW4 |
Switches , PS_SRST_B, PS_POR_B pushbuttons |
E-switch TL3301EP100QG |
12 |
24 |
SW16 |
Power On/Off Slide Switch , power ON/OFF slide switch |
C&K 1201M2S3AQE2 |
46 |
25 |
J52 |
Power On/Off Slide Switch , power connector |
MOLEX 39-30-1060 |
46 |
26 |
SW2 |
Program_B Pushbutton , PS_PROG pushbutton |
E-switch TL3301EP100QG |
12 |
27 |
J26 |
FPGA Mezzanine Card Interface , FMCP HSPC connector |
Samtec ASP_184329_01 |
33-37 |
28 |
- |
Board Power System , (top, [B]) |
Infineon regulators |
47-61 |
29 |
P11 |
DPAUX (MIO 27-30) , DisplayPort |
MOLEX 0472720001 |
22-23 |
30 |
J19 |
Monitoring Voltage and Current , PMBUS connector |
SULLINS PBC36SAAN |
26 |
31 |
J92 |
System controller, MSP430 SC emulation cable connector |
TYCO 5103308-2 |
32 |
32 |
SW6 |
RFSoC Device Configuration , FPGA MODE 4-pole DIP switch |
4-pole C&K SDA04H1SBD |
12 |
33 |
J5 |
SYSMON 2X6 vertical male pin header |
SULLINS PBC36DAAN |
3 |
34 |
J47 |
RF Data Converters , low profile array (LPAF) socket |
Samtec LPAF-40-03.0-S-08-2-K-TR |
63 |
35 |
J94 |
RF Data Converters , low profile array (LPAF) socket |
Samtec LPAF-40-03.0-S-08-2-K-TR |
64 |
36 |
U40 |
Amphenol MDT420M02001 |
31 |
|
37 |
M2CAGE1 |
PS M.2 SATA Connector , M.2 conn. EMI cage |
Leader Tech 20S-CBSFNSV-1.0x2.25x0.40 |
31 |
38 |
U52 |
Cooling Fan Connector , fan controller |
Maxim MAX6643LBBAEE++ |
46 |
39 |
J60 |
Cooling Fan Connector , fan controller |
Molex 22-11-2032 |
46 |
40 |
J14 |
User SMA MGT Clock , SMA USER_SMA_MGT_CLOCK_P |
Rosenberger 32K10K-400L5 |
8 |
41 |
J15 |
User SMA MGT Clock , SMA USER_SMA_MGT_CLOCK_N |
Rosenberger 32K10K-400L5 |
8 |
42 |
J95 |
User SMA MGT Clock , SMA RF_FPGA_REF_CLK |
Rosenberger 32K10K-400L5 |
4 |
43 |
J108 |
RF clocking, U90 LMK04208 RF REFCLK SMA |
Rosenberger 32K10K-400L5 |
67 |
44 |
J109 |
RF clocking, U90 LMK04208 RF external REFCLK SMA |
Rosenberger 32K10K-400L5 |
67 |
45 |
U90 |
RF clocking, LMK04208 RF REFCLK |
TI LMK04208 |
67 |
49 |
U102 |
RF clocking, ADC RFPLL |
TI LMX2594RHAT |
68 |
50 |
U103 |
RF clocking, DAC RFPLL |
TI LMX2594RHAT |
69 |
51 |
U104 |
RF clocking, ADC RFPLL |
TI LMX2594RHAT |
70 |
52 |
U6 |
System Reset Pushbuttons , power-on reset |
Maxim MAX16025TE+ |
12 |
53 |
U13 |
USB 3.0 Transceiver and USB 2.0 ULPI PHY , USB3 power switch, |
Micrel MIC2544A-1YM |
24 |
54 |
J20 |
System Reset Pushbuttons
,
|
SULLINS PBC36SAAN |
12 |
55 |
J8 |
System Reset Pushbuttons
,
|
SULLINS PBC36SAAN |
12 |
56 |
J9 |
System Reset Pushbuttons , 2-pin HDR MR_B (U6 MAX16025 POR) |
SULLINS PBC36SAAN |
12 |
57 |
U53 |
Board Power System
,
|
Infineon IRPS5401MXI04TRP |
47 |
58 |
U55 |
Board Power System
,
|
Infineon IRPS5401MXI04TRP |
49 |
59 |
U57 |
Board Power System
,
|
Infineon IRPS5401MXI04TRP |
51 |
60 |
U83 |
Power and Status LEDs , LED driver |
TI SN74AVC8T245PWR |
62 |
61 |
U84 |
Power and Status LEDs , LED driver |
TI SN74AVC8T245PWR |
62 |
62 |
U85 |
Power and Status LEDs , LED driver |
TI SN74AVC8T245PWR |
62 |
63 |
SW7 |
PB U42 MSP430 reset,
|
E-switch TL3301EP100QG |
32 |