The card has both network and card status LEDs.
The network LEDs are visible through cutouts in the PCIe® I/O bracket shown in the following figure.
The following table details the network LEDs along with schematic LED component reference designation. Each DSFP28 cage has two adjacent user definable RGB LEDs. Pin mapping details are provided in the XDC file.
Figure 1. Network LED Locations
| Port | Description | Schematic Reference |
|---|---|---|
| Network Cage 0 | User definable RGB LED. | DS11 for LED0 DS12 for LED1 |
| Network Cage 1 | User definable RGB LED. | DS13 for LED0 DS14 for LED1 |
The following image shows the location of the card status LEDs on the card. They might be difficult to see because they are covered by the back plate.
The following table details the card status LEDs along with schematic LED component reference designation.
Figure 2. Card Status LED Locations
| LED Name | Description | Schematic Reference |
|---|---|---|
| BOARD ALARM | - | DS15 |
| BOARD STATUS | - | DS16 |
| DONE | Illuminated green when the FPGA is successfully programmed. | DS7 |
| POWER GOOD | Illuminated green when card power is good. | DS10 |