After packaging, everything is set to run hardware emulation. To run emulation, use the following command (default TARGET=hw_emu):
make run_emu
or
###########################################################################
Hardware Emulation Goto:
$(BUILD_TARGET_DIR)/package
and do:
./launch_hw_emu.sh or ./launch_hw_emu.sh -g (for waveform viewer)...
When hardware emulation is launched, you see the QEMU simulator load. Wait for the autoboot countdown to go to zero. After a few minutes, the root Linux prompt comes up:
root@versal-rootfs-common-2023_2:~#
After the root prompt comes up, run the following commands to run the design:
cd /mnt
export XILINX_XRT=/usr
./gemm_dsp_xrt.elf a.xclbin
The gemm_dsp_xrt.elf executes. After a few minutes, you should see the output with TEST PASSED on the console. When this is shown, run the following keyboard command to exit the QEMU instance:
#To exit QEMU Simulation
Press CtrlA, let go of the keyboard, and then press x
To run with waveform, do the following:
cd $(BUILD_TARGET_DIR)/package
./launch_hw_emu.sh -g
The XSIM Waveform Viewer is launched. Drag and drop the signals into the viewer and click Play to start the emulation. Go back to the terminal and wait for the Linux prompt to show up. In the XSIM Waveform Viewer, you will see the signals you added to the waveform adjusting over the execution of the design. When this is done, hit the pause button and close the window to end the emulation.Data Integrity mismatch due to software issue in Hardware Emulation,Design works in Hardware run.