The following table shows the revision history for this document.
Section | Revision Summary |
---|---|
09/11/2022 Version 1.2.1 | |
General updates | Corrected publication date. |
09/08/2022 Version 1.2 | |
Complex Multiplier |
Expanded OPMODE Control description, adding definitions for the X,Y,Z,W multiplexers input/output relationships and descriptions of complex multiplication operations with equations. Added ALUMODE Control section describing control of operations performed by the final ALU. |
MACC Extension | New section added describing MACC operations. |
12/23/2020 Version 1.1.1 | |
General updates | Editorial updates only. No technical content changes. |
12/04/2020 Version 1.1 | |
Figure 1 | Updated to fix a connection on MUX from the output of the B2 register. |
Bus Multiplexer | Updated figure to add flop stages. Revised the table to update OPMODE settings. |
Division | Updated the dividing with multiplication case to change initial value Q[8-n] from B to A input. |
Square Root | Updated description to add the value for C. |
Clock Domain Crossing and Time Division Multiplexing | Updated description. |
DSPCPLX | Updated information related to Language Templates. |
Figure 1 | Updated figure to add a flop stage in PL as well as in DSP2. |
Figure 2 | Updated to share data_dp0 between the two DSP58s at the bottom, as well as add a flop after pre-adder in the two DSP58s at the bottom. Also, staged FPINMODE. |
Resource Utilization Guideline | Updated LUTRAM to SRL16/LUTRAM in the description. Updated figure to add signal RE from control to the coefficients block. |
Single Multiplier MACC FIR Filter | Updated implementation description. |
Symmetric MACC FIR Filter | Updated the FIR filter equation. Updated figure to add flop stages to A/B/D inputs of DSP58, as well as updated the input and output data width. |
Three Multiplier Semi-Parallel FIR Filter | Updated description to add number of taps. Updated figure to add flop stages to inputs A and B for all the DSP58s and added WE3 in control logic to control the output flop. |
Systolic FIR Filter | Added a note about swapping the A and B inputs in the systolic multiply-add processing element. Updated figure to add a note about C. |
Symmetric Systolic FIR Filter | Updated equation. |
Interpolating | Updated number of taps to 12. Updated figure to add a flop stage to input B. |
Figure 1 | Updated to add a flop stage to inputs A and B. |
Decimating | Updated figure to add a flop stage to input B. Updated the equation for initial latency. |
Floating Point FIR Filter | Updated description to add information about C in OPMODE. |
Complex FIR Filter | Updated equations. |
07/16/2020 Version 1.0 | |
Initial release. | N/A |