The parallel clock outputs from the RX clock divider control block can be used as an interconnect logic clock depending on the line rate and protocol requirements.
The recommended clock for the interconnect logic is the CH*_RXOUTCLK from one of the GTM transceivers. It is also possible to bring the MGTREFCLK directly to the interconnect logic and use it as the interconnect logic clock.
The RXOUTCLKCTL attribute controls the input selector and allows these clocks to be output via the CH*_RXOUTCLK port:
-
3'b001: The divide-by-two version of RXPHYCLK. -
3'b010: RXPHYCLK is the recovered clock that can be brought out to the interconnect logic. The recovered clock is used by protocols that do not have a clock compensation mechanism and require to use a clock synchronous to the data (the recovered clock) to clock the downstream interconnect logic. It is also used by the RX PCS block. This clock is interrupted when the PLL or CDR is reset by one of the related reset signals. -
3'b011: RXREFCLKPMA is the input reference clock to the LCPLL. For usages that do not require outputting a recovered clock to the interconnect logic, RXREFCLKPMA can be used as the system clock. However, CH*_TXOUTCLK is usually used as a system clock. -
3'b100: The divide-by-two version of RXREFCLKPMA. -
3'b101: RXPRODIVCLK is the divided down PLL clock after the RX programmable divider. See RX Fabric Clock Output Control for more details.