When the KC705 evaluation board is selected in the Vivado Design Suite project options, an XDC file is generated to target the example design to the KC705 board. The LED functions for the KC705 evaluation board are described in the following table.
| LED Location | Signal Name | Indication |
|---|---|---|
| GPIO_LED1 | mtrlb_activity_flash | Activity. Blinking LED indicates that pattern checker is receiving frames. |
| GPIO_LED2 | mtrlb_pktchk_error | Error. Illuminated LED indicates that pattern checker has received an error packet. |
The push button functions for the KC705 board are described in the following table.
| Switch | Signal Name | Function |
|---|---|---|
| SW6 | start_config | Update configuration. When pressed, the push button configuration is applied to the example design. |
| SW7(CPU_RESET) | sys_rst | System reset. |
| SW14(FPGA_PROG_B) | FPGA configuration reset. |
DIP switch SW11 functions for the KC705 board are described in the following table.
| Switch Position | Function |
|---|---|
| 4’h1 | Set bit rate to 1 Gbps. |
| 4’h2 | Set bit rate to 100 Mbps. |
| 4’h3 | Set bit rate to 10 Mbps. |
| 4’h4 | Reset packet check error. |
| 4’h5 | Set BIST mode, loopback at PHY interface. |
| 4’h9 | Set demonstration mode, loopback at AXI4-Stream interface. |