Calibration Modes - 2.6 English

Zynq UltraScale+ RFSoC RF Data Converter v2.6 Gen 1/2/3/DFE LogiCORE IP Product Guide (PG269)

Document ID
PG269
Release Date
2023-10-18
Version
2.6 English

To achieve specified RF-ADC performance, certain calibration mode must be set correctly according to the signal location. The available calibration modes are listed as follows:

  • Mode 1, optimized for the input signal locates from 0.4 * Fs to Fs/2
  • Mode 2, optimized for the input signal locates from 0 to 0.4 * Fs

The above location refers to the input signals in the first Nyquist band after aliasing.

AutoCal Mode
This mode is available in Gen 3/DFE. The AutoCal mode removes the manual selection of Mode 1 and Mode 2 calibrations and optimizes the RF-ADC performance regardless of signal locations.