Setup - 2.0 English

SMPTE UHD-SDI Receiver Subsystem Product Guide

Document ID
PG290
Release Date
2022-04-26
Version
2.0 English

The reference design runs on the Xilinx Versal Evaluation Board (VCK190) or Xilinx Versal ES1 Evaluation Board (VCK190), using the SDI available on the board, as shown in the example in This Figure .

Note: In the following procedure, the numbers in parentheses correspond to the call out numbers in This Figure .

Figure 5-49: VCK190 Board Setup

X-Ref Target - Figure 5-49

X24902-vck190_Board_setup.png

1. Connect a USB cable from the host PC to the USB JTAG port (1). Ensure the appropriate device drivers are installed.

2. Connect a second USB cable from the host PC to the USB UART port (2). Ensure that the USB UART drivers described in Hardware have been installed.

3. Insert a Fidus FMC card into FMC slot (3).

4. Connect the HD-BNC of FMC Card (4) to the SDI source device.

5. Connect the HD-BNC of FMC Card (7) to the SDI sink device.

6. Connect the VCK190 board to a power supply slot (5).

7. Switch on the VCK190 board (6).

8. Make sure that the HW-VCK190 board revision is as selected in GUI interface.

9. Ensure that the SMPTE ST 352/Payload ID is enabled in the SDI Stream connected to the SDI input link of VCK190.

10. Start Tera Term or PuTTY to connect to the COM port interface 0 on the Host PC configured with 115200 bps, 8 bits, No parity, 1 stop bit, and no flow control.