Alarms Signals

Zynq UltraScale+ Device Technical Reference Manual (UG1085)

Document ID
UG1085
Release Date
2022-09-15
Revision
2.3 English

Each sensor channel can assert an alarm. The CONFIG_REG registers in each SYSMON can be configured to disable each alarm before it is routed to the PMU, CSU, PL, and the AMS interrupt registers. The alarm signals are shown in This Figure. Several voltage nodes measured by the PS SYSMON unit are only accessible via the AMS register set and do not have alarms, see Table: Measurement Registers in AMS Register Set.