Full-Power Operation Mode

Zynq UltraScale+ Device Technical Reference Manual (UG1085)

Document ID
UG1085
Release Date
2023-12-21
Revision
2.4 English

All domains are powered in the full-power mode, so the LPD is typically powered whenever FPD is powered. Like the low-power mode, power dissipation depends on the components that are running and their frequencies.

Note:   If the FPD is needed at any point, it must be powered during the initial boot. This does not apply if the FPD is never used.

Figure 6-1:      Power Domains and Islands

X-Ref Target - Figure 6-1

X16958-power-domain.jpg