Initialize PCAP Interface

Zynq UltraScale+ Device Technical Reference Manual (UG1085)

Document ID
UG1085
Release Date
2023-12-21
Revision
2.4 English

1.Take the PCAP out of reset. Write 1 to the csu.pcap_reset[reset] bit.

2.Configure the PCAP in write mode.

a.Select the PCAP mode. Write 1 to the csu.pcap_ctrl[pcap_pr] bit.

b.Select write mode. Write 0 to the csu.pcap_rdwr[pcap_rdwr_b] bit.

3.Power up the PL, if needed. Read the csu.pcap_status [pl_gpwrdwn_b]. If Off, then trigger a request to the PMU to power up the PL using the pmu_global.req_pwrup_trig [PL] bit.

4.Reset the PL.

a.Assert the PL reset. Write 0 to the csu.pcap_prog [pcfg_prog_b] bit.

b.Wait for at least 250 ns.

c.Deassert the PL reset. Write 1 to the csu.pcap_prog [pcfg_prog_b] bit.