Quad SPI

VCU128 Evaluation Board User Guide (UG1302)
Document ID
UG1302
Release Date
2022-05-06
Revision
1.2 English
To boot from the dual Quad SPI non-volatile configuration memory, follow these steps.
  1. Store a valid XCVU37P FPGA boot image in the 2 Gbit Quad SPI flash device (U46) connected to the FPGA bank 0 Quad SPI interface. See the VCU128 Restoring Flash Tutorial (XTP533) for information on programming the QSPI.
  2. Set the boot mode pins SW1 M[2:0] as indicated in the configuration modes table in FPGA Configuration for master SPI.
  3. Power-cycle the VCU128 board. Mode SW1 is callout 36 in Figure 1.

See the VCU128 Software Install and Board Setup Tutorial (XTP535) for more information.

See System Controller for an overview of query and control of select programmable board features such as clocks, FMCP functionality, and power systems. See the VCU128 System Controller Tutorial (XTP534) for more information.