QSPI32

VCK190 Evaluation Board User Guide (UG1366)
Document ID
UG1366
Release Date
2023-03-17
Revision
1.1 English

This boot mode is supported only with boot module X-EBM-01 attached to the MIO connector (J212). The X-EBM-01 boot module contains 2x1Gb MT25QU01GBBB8E12-0SIT high-performance multiple input/output, SPI flash memory devices. J212 is a 240-pin (8 x 30) MIO connector wired to XCVC1902 U1 bank 500 PMC_MIO[0:12] pins. The supported QSPI configurations are x1, x2, x4, and dual-parallel x8. To boot from a QSPI X-EBM-01 boot module:

  1. Store a valid XCVC1902 ACAP boot image file on the X-EBM-01 resident QSPI.
  2. Set boot mode SW1 for QSPI32 as indicated in the "Mode Switch SW1 Configuration Option Settings" table in Versal ACAP Configuration.
  3. Power-cycle the VCK190 or press the POR pushbutton SW2. SW2 is callout 35 in the "Evaluation Board Component Locations" figure in Board Component Location.