Versal ACAP Configuration

VCK190 Evaluation Board User Guide (UG1366)
Document ID
UG1366
Release Date
2023-03-17
Revision
1.1 English

The Versal XCVC1902 ACAP boot process is described in the “Platform Boot, Control, and Status” section of the Versal ACAP Technical Reference Manual (AM011). The VCK190 board supports a subset of the modes documented in the technical reference manual via onboard and daughter card boot options. The mode DIP switch SW1 configuration option settings are listed in the following table.

Table 1. Mode Switch SW1 Configuration Option Settings
Boot Mode Mode Pins [3:0] 2 Mode SW1 [4:1] 2 Comments
JTAG 0000 1, 3 ON, ON, ON, ON Supported with or without boot module attached
QSPI32 0010 ON, ON, OFF, ON Supported only with boot module X-EBM-01 attached

Supports x1, x2, x4, and dual-parallel x8
SD1_3.0 1110 OFF, OFF, OFF, ON Supported with or without boot module attached
  1. Default switch setting.
  2. Mode DIP SW1 poles [4:1] correspond to U1 XCVC1902 MODE[3:0].
  3. Mode DIP SW1 individual switches ON=LOW (p/d to GND)=0, OFF=HIGH (p/u to VCCO)=1.