If the number of control sets is high, use one of the following strategies to reduce their number:
- Remove the MAX_FANOUT attributes that are set on control signals in the HDL sources or constraint files. Replication on control signals dramatically increases the number of unique control sets. AMD recommends relying on
place_designto perform coarse replication and using
phys_opt_design -directive Explorefor finer replication after placer. This prevents unnecessary replication and equivalent control sets from crossing each other, which can lead to routing congestion.
- Increase the control set threshold of Vivado
synthesis (or other synthesis tool). Review the control sets fanout distribution
report_control_sets -verboseto determine a more appropriate control sets threshold to use during synthesis. Note that increasing
contol_set_optcan have negative impacts on power by eliminating clock enables that can actively reduce power. For example:
synth_design -control_set_opt_threshold 16Tip: Use the BLOCK_SYNTH synthesis constraints to change the control sets threshold on modules that are the most impacted by placement spreading or congestion.
opt_design -merge_equivalent_driversto merge equivalent control sets after synthesis.
- Use the CONTROL_SET_REMAP property to map low-fanout control signals driving the synchronous set/reset and/or CE pin of a register to the D-input. For more information, see this link in the Vivado Design Suite User Guide: Implementation (UG904).
- Avoid low fanout asynchronous set/reset (preset/clear), because they can only be connected to dedicated asynchronous pins and cannot be moved to the datapath by synthesis. For this reason, the synthesis control set threshold option does not apply to asynchronous set/reset.
- Avoid using both active-High and active-Low of a control signal for different sequential cells.
- Only use clock enable and set/reset when necessary. Often data paths contain many registers that automatically flush uninitialized values, and where set/reset or enable signals are only needed on the first and last stages.