Start/Stop reading from JTAG UART.
Start/Stop reading from the Arm DCC or MDM UART TX interface. JTAG UART output can be printed on stdout or redirected to a file.
||Start reading the JTAG UART output.|
||Stop reading the JTAG UART output.|
||Specify the file handle to which the data should be redirected. If no file handle is given, data is printed on stdout.|
- Select a MDM or Arm/MicroBlaze processor target before runnning this command.
- While running a script in non-interactive mode, output from JTAG UART may not be written to the log, until "readjtaguart -stop" is used.
Nothing, if successful. Error string, if data cannot be read from the JTAG UART.
Start reading from the JTAG UART and print the output on stdout. set fp [open test.log w]; readjtaguart -start -handle $fp Start reading from the JTAG UART and print the output to test.log.
Stop reading from the JTAG UART.