LEDs

T1 Telco Accelerator Card User Guide (UG1495)

Document ID
UG1495
Release Date
2021-12-17
Revision
1.0 English

The LEDs on the T1 card are listed in the following table.

Table 1. T1 Card LEDs
Ref Des LED Name Description
D8 VCC_ATX_12V_IN Green LED. On when 12V ATX power source is present. Off if 12V power source is not present.
D10 SC_STATUS_LED Green LED. On when SEQ3 PG is high. Off if power sequence is not initialized properly. Blinks at an interval of every four seconds before thermal shutdown.
D12 RF_CONFIG_DONE Orange LED. On when the Zynq UltraScale+ RFSoC PL configuration is completed.
D13 RF_LED Green LED. Connected to SoC for workload usage. LED is user defined.
D14 RF_PS_TEST_LED Green LED. Connected to SoC for workload usage. LED is user defined.
D15 MP_CONFIG_DONE Orange LED. On when the Zynq UltraScale+ MPSoC PL configuration is completed.
D16 MP_LED Green LED. Connected to SoC for workload usage. LED is user defined.
D17 MP_PS_TEST_LED Green LED. Connected to SOC for workload usage. LED is user defined.