Windows USB 3.0 Driver Setup

SmartLynq+ Module User Guide (UG1514)

Document ID
UG1514
Release Date
2021-03-08
Revision
1.0 English

The Windows 10 included RNDIS driver needs to be associated with the SmartLynq+ Module. These are the steps to associate the cable to the driver. You might need to repeat these steps if you connect the SmartLynq+ Module to a different port on the Windows PC.

  1. Connect the SmartLynq+ Module to a Windows PC using the USB-B cable.
  2. Open Device Manager. You should see a device named RNDIS.
  3. Right-click the RNDIS device and click Update Driver.
  4. A new window pops up. Click Browse my computer for driver software..
  5. Click Let me pick from a list of available drivers of my computer.
  6. Select Network adapters from the list and click Next.
  7. Select Microsoft from the Manufacturer list and select USB RNDIS Adapter from the Model list. Click Next.

  8. You will now see an Update Driver Warning. Click Yes to proceed.
  9. You should now see the driver successfully installed.
  10. Open the Windows network connections panel.
  11. You should see a device with the description USB RNDIS Adapter.

  12. Right-click this adapter and click Properties.
  13. Select Internet Protocol Version 4 (TCP/IPv4) from the list and click Properties.
  14. A new window pops up. Configure the network interface as follows and click OK.
  15. You should now be able to access the SmartLynq+ Module at 10.0.0.2