MIPI D-PHY

UltraScale Architecture SelectIO Resources User Guide (UG571)

Document ID
UG571
Release Date
2022-08-31
Revision
1.14 English

The MIPI D-PHY standard MIPI_DPHY_DCI is intended for use in mobile devices including cameras, displays, and unified protocol interfaces. This standard is only supported in the HP I/O banks of the Virtex UltraScale+, Kintex UltraScale+, and Zynq UltraScale+ devices. Support for this standard in UltraScale devices is in adherence to the MIPI Alliance interface specifications.

 

IMPORTANT:   MIPI_DPHY_DCI, as with other DCI standards, requires a 240W external resistor at the VRP Pin. This standard does leverage calibration on the LP driver even though the values for the OUTPUT_IMPEDANCE attribute are not configurable.