phys_opt_design command runs physical optimization on the
design. It can be run in post-place mode after placement and in post-route mode
after the design is fully-routed.
phys_opt_design [-fanout_opt] [-placement_opt] [-routing_opt] [-slr_crossing_opt] [-insert_negative_edge_ffs] [-restruct_opt] [-interconnect_retime] [-lut_opt] [-casc_opt] [-cell_group_opt] [-critical_cell_opt] [-dsp_register_opt] [-bram_register_opt] [-uram_register_opt] [-bram_enable_opt] [-shift_register_opt] [-hold_fix] [-aggressive_hold_fix] [-retime] [-force_replication_on_nets <args>] [-directive <arg>] [-critical_pin_opt] [-clock_opt] [-path_groups <args>] [-tns_cleanup] [-sll_reg_hold_fix] [-quiet] [-verbose]
-tns_cleanupoption can only be run in conjunction with the
phys_opt_design Example Script
open_checkpoint top_placed.dcp # Run post-place phys_opt_design and save results phys_opt_design write_checkpoint -force $outputDir/top_placed_phys_opt.dcp report_timing_summary -file $outputDir/top_placed_phys_opt_timing.rpt # Route the design and save results route_design write_checkpoint -force $outputDir/top_routed.dcp report_timing_summary -file $outputDir/top_routed_timing.rpt # Run post-route phys_opt_design and save results phys_opt_design write_checkpoint -force $outputDir/top_routed_phys_opt.dcp report_timing_summary -file $outputDir/top_routed_phys_opt_timing.rpt
phys_opt_design example script runs both post-place and
post-route physical optimization. First, the placed design is loaded from a
checkpoint, followed by post-place
phys_opt_design. The checkpoint
and timing results are saved. Next the design is routed, with progress saved
afterwards. That is followed by post-route
saving the results. Note that the same command
used for both post-place and post-route physical optimization. No explicit options
are used to specify the mode.