The primary configuration mechanism for the programmable logic (PL) of Zynq 7000 and Zynq UltraScale+ MPSoC devices is through the processing system (PS), which delivers bitstreams to the PCAP. The most common mechanism for partial reconfiguration is also through this path. However, to manage partial reconfiguration completely within the PL (either through the PR Controller IP or through a custom-designed controller module), partial bitstreams can also be delivered to the ICAP, just as they can be for FPGA devices.
The PCAP and ICAP interfaces are mutually exclusive and cannot be used simultaneously. Switching between ICAP and PCAP is possible, but you must ensure that no commands or data are being transmitted or received before changing interfaces. Failure to do this could lead to unexpected behavior.
To enable the ICAP for Zynq 7000 devices, set bit 27 (
PCAP_PR) of the Control Register (
devc.CTRL). This bit selects between ICAP and PCAP for PL reconfiguration.
The default is
PCAP (1), but that can be changed to
ICAP (0) to enable this configuration port. Note
that bit 28 (
PCAP_MODE) must also be set to 1, which is
the default. For more details, see the .
To enable the ICAP for Zynq UltraScale+ MPSoC devices, set
PCAP_PR field of the
pcap_ctrl (CSU) register. This bit selects between ICAP (or MCAP) and PCAP
for PL reconfiguration. The default is
PCAP (1), but
that can be changed to
MCAP (0) to enable this configuration port. For more details, see the
Zynq UltraScale+ Device Technical Reference Manual (UG1085) and the
Zynq UltraScale+ Device Register Reference (UG1087).
The Zynq UltraScale+ MPSoC Xilfpga library supports the delivery of partial bit files for Linux and bare-metal applications. In the current release, only non-secure bitstreams (without encryption or authentication) are supported. For more information and examples, visit the Xilfpga wiki page (www.wiki.xilinx.com/xilfpga).