Board designers are faced with a unique task when designing a power distribution system (PDS) for an AMD device. Most other large, dense integrated circuits (such as large microprocessors) come with very specific bypass capacitor requirements. Because these devices are designed only to implement specific tasks in their hardened silicon architecture, their power supply demands are fixed and fluctuate typically within a certain range.
AMD adaptive SoCs do not share this property. Devices can implement an almost infinite number of applications at user-determined frequencies, and in multiple clock domains.
For this reason, it is critical that you understand the power requirements of the design, which you can assess by completing a power estimation using the Xilinx Power Estimator (XPE) spreadsheet tool (download at www.xilinx.com/power). Also refer to the PCB Design Guide for your device to fully understand the PDS placement and generic decoupling requirements prior to a power estimation.
Key factors to consider during PDS design include:
- Selecting the right voltage regulators to meet the noise and current
requirements based on power estimation.
Note: To enable and simplify your power design, AMD partners with key power vendors to design, build, document, and test reference designs that meet all power requirements. For more information, see the Power Delivery Solutions tab on the Power web page.
- Consolidating power. For
supported consolidation options in AMD UltraScale™
devices, see Power Distribution System in UltraScale
Devices in the
Architecture PCB Design User Guide (UG583).
Power Tip: AMD recommends adding a shunt resistor to allow the power on each rail to be monitored. Alternatively, you can use a PMBus-enabled regulator or current monitoring integrated circuit (IC).
- Setting up the Sysmon power supply (VCCAUX_SMON).
- Running power distribution network (PDN) simulation. For UltraScale devices, use the recommended number of decoupling capacitors listed in the UltraScale Architecture PCB Design User Guide (UG583), which are based on the assumptions listed in the guide. If the assumptions differ for your design, simulate your design to determine whether more or less decoupling is required. Running PDN simulations can help to confirm the exact amount of decoupling capacitors required to guarantee power supplies that are within the recommended operating range.
For more information on PDN simulation, see Simulating FPGA Power Integrity Using S-Parameter Models (WP411).
report_powercommand can analyze power on a per regulator or voltage regulator module (VRM) basis to ensure the required current on each rail does not exceed the intended power delivery system.