A prom image of the design can be loaded into the local QSPI flash to be automatically delivered upon power-up of the board.
- Right-click the device (KU5P or VU9P), and select Add Configuration Memory Device.
- From the list of configuration memory parts, select mt25qu01g-spi-x1_x2_x4_x8. You must select this
part (which includes _x8), because the PROM image is set
for dual QSPI.
- Click OK, and then click OK again when asked if you want to program this device now.
- When asked if you want to program the device now, click OK, which opens Program Configuration Memory
Device.
- For Configuration file, select PR_over_PCIe_prom_primary.mcs.
- For Configuration file 2, select PR_over_PCIe_prom_secondary.mcs.
- To erase the program from the flash target, click OK.
- After this completes, ensure the
Mode
pins are set to Master SPI mode before pushing PROG or re-powering the board. - Ensure the following values are set to 0:
- KCU116
- Bit 6 on SW21
- VCU118
- Bit 2 on SW16