The initial configuration of the
device can be achieved via JTAG or dual QSPI. To configure the device via JTAG, perform
the following steps.
- If necessary, launch the Vivado IDE, and select Open Hardware Manager.
- Connect to the target board.
- Right-click the device (KU5P or VU9P), and select Program Device, which opens a dialog box.
- For Bitstream file, select design_1_wrapper.bit from the Bitstreams folder.
- For Debug probes file, select design_1_wrapper_shift_right.ltx.
- Click Program.
The result is that four LEDs shift to the right after DONE goes high.