Running the Simple Example on the ZCU102 Board

Memory and Peripheral Protection Unit for PL Isolation in Zynq UltraScale+ Devices (XAPP1353)

Document ID
Release Date
v1.1 English

The procedure for setting up the evaluation board is provided in the previous example, ZCU102 Evaluation Board Setup. Copy the BOOT.bin file for the RPU simple example application <build_path>/rpu_xmpu_example/BOOT.bin to the SD Card, place the SD card into socket J100, and power the board. If the board is already powered, then cycle PROG_B by pressing SW4.

After completing the initial boot, the PL portion of the fault injection test, also demonstrated in the previous example, runs and displays its output to terminal 1. See the following figure for reference.

Figure 1. Simple XMPU_PL Example Output