- Copy the BOOT.bin to the ZCU102 SD card, that was created in the previous step.
-
Connect the UART cable and
power cable to the board. Set the COM
port to an appropriate value for your computer. Set the
Baud Rate to
115200. Open a UART terminal to communicate with the software running on the PS. - Configure the Board to Boot in SD-Boot mode by setting switch SW6 to 1-ON, 2-OFF, 3-OFF, and
4-OFF as shown in the following figure.Figure 1. SW6 Switch Settings for SD Boot Mode
- Load the SD card into the ZCU102 board and power-up the board. You can see
the boot image loaded successfully and LEDs are blinking.Figure 2. Board after BOOT