1. Set up the hardware connections as shown in This Figure .
a. Mount the LI-IMX274MIPI-FMC Camera sensor module on the VCK190 board FMCP1 Slot.
b. Connect the HDMI cable to the VCK190 HDMI port ( This Figure ).
c. Connect the other end of the HDMI cable to the HDMI monitor.
d. Switch on the HDMI monitor, and select HDMI as input source.
e. Connect the USB-JTAG programming cable from host PC to JTAG type c USB port of board.
f. Ensure that the SD card, board switches and jumpers are in position as shown in This Figure .
g. Connect the USB UART and JTAG programming cables to the Windows host computer where xsdb and hw_server is running.
2. Connect the power supply cable and turn on the VCK190 board.
3. Start a Hyper Terminal program on the host PC with the following settings:
° Baud rate: 115200
° Data Bits: 8
° Parity: None
° Stop Bits: 1
° Flow Control: None
Note: Ensure that V adj is set to 1.5V. Refer to the VCK190 board documentation for details.