Running the Tests - 1.0 English

T1 Telco Accelerator Card Installation Guide (UG1518)

Document ID
UG1518
Release Date
2021-12-17
Version
1.0 English

The skeleton design has the following setup to test the T1 card.

Figure 1. Test Setup

The following section describes each test, including setup, running, and expected results. The primary objective of testing is to verify the following main interfaces, and then to verify data transfer by comparing the output with expectations.

  • 100G internal MAC connection between Zynq UltraScale+ MPSoC and Zynq UltraScale+ RFSoC
  • 2 x 25G external SFP connectors in Zynq UltraScale+ MPSoC
  • ZU21 Zynq UltraScale+ RFSoC PCIe x8 interface
  • ZU19 Zynq UltraScale+ MPSoC PCIe x8 interface
  • ZU19 Zynq UltraScale+ MPSoC
  • ZU21 Zynq UltraScale+ RFSoC PS/PL DDR4